Workshop spray foam lets you heat a steel shop or old drive shed and actually keep the heat. Foam across the walls and roof stops drafts and keeps warm air from escaping through bare sheeting.
Elmira Spray Foam Insulation covers every project with full insurance. Your quote comes in writing after we see the building in person.
Workshop spray foam stops heat from leaving through the roof, which is where most of it goes. Warm air rises, and in a bare shop it reaches cold steel and is gone within minutes.
A sealed roof keeps that heat down near the bench where you work. A woodstove or a unit heater can then hold a steady temperature rather than running flat out. The steel stops sweating too, so tools and welders stay dry.
Workshop spray foam usually needs a cover once a shop is heated and people work in it. Drywall is the most common cover. A fire-rated paint can work on steel framing where drywall is hard to hang.
The building department decides what each building needs, and that matters most when an old drive shed near Floradale or Bloomingdale changes use. We bring it up on the first visit, so the cover is in your plan and your budget from day one.
Foam needs care around overhead and sliding doors. We spray right to the door frame and cut clean edges so the door still runs freely. The header over a wide door is a common leak spot, and we seal it with extra care.
Weatherstrip on the door itself still matters. The foam handles the walls and roof, and the two together make the biggest change to your heating bill.
A woodworking shop needs steady humidity so boards do not cup. A welding shop needs dry steel. An engine shop needs heat on a cold Monday. Workshop spray foam helps with all three. For smaller garages at the house, see our garage foam page.
Workshop spray foam on the lower walls cuts the cold that pools along the slab. In a steel shop, wind pushes under the base trim and across the floor, right where you kneel to work on a mower or a hitch. Sealing that bottom girt line takes the bite off the floor.
Some shop owners add in-floor heat or a radiant tube heater later. Both work better when the walls and roof get workshop spray foam first, because the heat stays inside instead of leaking out at the base trim and the ridge. If a heated floor is in your plans, tell us at the visit and we will set the foam depth around it.
Workshop spray foam in Ontario generally falls between $2 and $5 per square foot. Phone (226) 407-7743 and we will come look at your shop for free. Or head back to the spray foam insulation main page and browse the barn, house and shop work we do.
One trip down the lane often covers the farmhouse, the shop and the hog barn.
Pole barn spray foam insulation bonds to the roof steel and wall sheets of a post frame building, so frost and sweat have no cold face to form on. A single closed cell layer wraps the ribs and the girts.
View Pole Barn Spray Foam
Livestock barn spray foam insulation keeps the moisture from animals' breath off the roof and walls, so steel stays dry and rafters stay sound. Closed cell foam takes a pressure washer and gives pests no fluff to nest in.
View Livestock Barn Spray Foam
Attic spray foam insulation plugs the leaks in a ceiling and adds R-value on the same trip. It suits century farmhouses, village homes and newer houses with awkward roof lines.
View Attic Spray Foam
Basement spray foam turns a cold foundation into a warm, dry wall that is ready for studs. Closed cell foam grips block, stone and poured concrete alike.
View Basement Spray Foam
Crawl space spray foam insulation coats the block walls and rim of a short crawl space, keeping the kitchen floor warm and the water lines thawed. Closed cell foam holds back ground moisture as well as cold air.
View Crawl Space Spray Foam
Garage spray foam stops the chill that seeps from a garage into the bedroom above it and the kitchen beside it. It also turns the garage into a warmer spot to work, park and store things.
View Garage Spray Foam
New home spray foam fills the walls, rim boards and roof of a house while the studs are still bare. That stage is the easiest time to build a tight, quiet, efficient home.
View New Home Spray Foam
Closed cell spray foam cures hard and dense, so one coat of it insulates, air seals and blocks water vapour together. We spray more of it on farm buildings, foundations and steel roofs than anything else.
View Closed Cell Spray FoamSend the building type and rough size, and we try to call back before the business day ends.
A few details about the building are enough, and a call follows to fit a visit around milking or chores. Calls go to +1 (226) 407-7743.
